![background image](/i/bmw/160195/bmw-c1-2001/h/bmw-c1-2001-200.png)
24.8
Installing variator
e
Attention:
Make sure the belt contact faces are perfectly clean
and free of oil and grease!
Install drive variator (lubricated version)
•
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following:
•
Apply an even coat of approximately 20 g
(0.7 oz) of grease to the curved tracks of the in-
ner plate and install the rollers
•
Lightly grease O-ring and install
•
Install spring clamp, guides on transfer element
and grease the recesses in the guides
•
Uniformly grease interior of spacer
•
Spray ground faces of crankshaft stub
•
Insert transfer element
•
Check action of transfer element
•
Secure variator cover
Fluids and lubricants:
Shell Retinax HDX2 .......approximately 20 g (0.7 oz)
Spacer and running
surface ..............................Klüber paste 46 MR 401
Crankshaft stub.................Klüber paste 46 MR 401
Drive variator mount .............................. Loctite 243
X
Torque specification:
Variator cover mount ...................................... 4 Nm
Drive variator mount
(+ LOCTITE 243) .......................................... 60 Nm
Variator cover............................................... 10 Nm
Vent cover...................................................... 9 Nm
Install drive variator (unlubricated version)
•
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following:
•
Unlubricated drive variator assembly/installation
-
do not
grease
•
Check action of transfer element
X
Torque specification:
Drive variator mount
(+ LOCTITE 243) .......................................... 60 Nm
Variator cover............................................... 10 Nm
Vent cover...................................................... 9 Nm
C1111300
C1000490