![background image](/i/bmw/160195/bmw-c1-2001/h/bmw-c1-2001-373.png)
46.55
Installing powertrain cradle mounts
•
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following:
•
Installing and adjusting coupling for swing arm
mounts
Adjustment data:
•
Tighten swing arm coupling (1) on left to speci-
fied torque then loosen half a turn
X
Torque specification:
Engine mount ............................................... 73 Nm
Rubber bushing mount................................. 42 Nm
Fastener for coupling, swing arm
mount, right.................................................. 73 Nm
Swing arm coupling on left
1. ................................................................. 20 Nm
2. ...................................................Loosen 1/2 turn
Locknut on left bearing pin ......................... 105 Nm
46 51 050
Rear frame member replace-
ment
–
Remove the rear storage compartment
–
Remove left and right rear side trim panels
•
Raise C1 slightly with hoist,
BMW No. 00 1 570
•
Open cable ties (arrows)
•
Disconnect plugs (1) for left turn indicator and
taillamp cluster
•
Remove fastener (2) for taillamp cluster
•
Remove taillamp cluster
•
Remove fastener (4) of rear frame
•
Remove fastener (3) securing spring strut to rear
frame
C1460650
1
C1130050
00 1 570
C1460770
1
2
4
3