![background image](/i/bmw/160195/bmw-c1-2001/h/bmw-c1-2001-408.png)
61.16
Filler hose
Removing and installing filler hose
For the sake of clarity, these illustrations show the
vehicle withcertain trim panels removed!
–
Remove front fairing panel
–
Swing the headlight forward and down
–
Remove sill centre section
a
....................................................See Group 46
•
Disconnect filler hose (arrows) from fluid
reservoir (4)
•
Turn the handlebars all the way to the right
•
Open cable clips (3, 5) on frame
•
Pry filler funnel (1) out of holder (2)
•
Disconnect filler hose (arrow) from filler funnel
•
Pull filler hose down to remove
When installing:
•
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following:
•
Make sure the hoses are routed well away from
any components that could cause rubbing and
abrasion
•
Install filler hose from below
•
Pass filler hose through holder of filler funnel
•
Connect filler funnel to filler hose
•
Press filler funnel into its holder
•
Secure filler hose, starting at the top and working
down
C1610161
3
5
1
4
2