![background image](/i/bmw/160195/bmw-c1-2001/h/bmw-c1-2001-358.png)
46.40
L
Note:
The stud is knurled on the right!
•
Remove circlip (1)
e
Attention:
When tapping out the stud - take care not to dam-
age the groove for the circlip!
•
Remove stud (2) by tapping to the right
•
Fold the large lever on the easy-lift mechanism
down to retract
•
Detach the stand Bowden cables from the easy-
lift mechanism's small lever
•
Remove the lever
When installing:
•
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following:
•
Before installing the lever check the guide (1)
and support (2) to ensure that components
movely freely with no excess friction or resist-
ance
•
Ensure that the guide (1) and the support (2) are
installed in the correct positions
•
When installing the small lever ensure that the
guide (1) is on the top and that it is positioned
against the right side of the small lever
•
When installing the large lever ensure that it is
above the support (2)
e
Attention:
Take care to avoid damaging the plastic sleeves!
L
Note:
The knurled side of the stud is on the right!
•
Checking operation
–
Bowden cable free travel in stand control, check-
ing, adjusting as necessary (
X
Torque specification:
Eye bolt attachment ....................................... 8 Nm
C1310340
1
2
C1310380
2
1