![background image](/i/bmw/160195/bmw-c1-2001/h/bmw-c1-2001-213.png)
24.21
When installing:
L
Note:
Grease one side of a thrust washer for intermediate
shaft and attach it to side of large gear!
•
Install seal plug with copper seal
•
Oil stub of intermediate shaft and install
•
Position variator shaft in cover
•
Position output shaft in grooved ball bearing
•
Mount second thrust washer on intermediate
shaft
•
Install seal
Fluids and lubricants:
shaft oil seal seats............ Klüber paste 46 MR 401
Shaft seats ....................... Klüber paste 46 MR 401
X
Torque specification:
Drain plug..................................................... 20 Nm
Filler plug ....................................................... 5 Nm
Gearbox cover ............................................. 11
Nm
# Replacing housing shaft oil seal on
output shaft
L
Note:
Additional work necessary if powertrain cradle is to
remain installed:
- Remove rear wheel (
- Use strut support
–
Remove complete variator assembly (
–
–
Removing gearbox shafts (
•
Pry out shaft oil sealing ring, using an angled
screwdriver with a second screwdriver for lever-
age, or with screwdriver resting on housing
C1110720
C1110730