![background image](/i/bmw/160195/bmw-c1-2001/h/bmw-c1-2001-062.png)
00.52
When installing:
•
Installation is the reverse of the removal proce-
dure
–
Add brake fluid up to the top of the sight glass
–
Bleed the rear brake circuit
•
Check the function of the brake system
Bleeding rear brake circuit
e
Attention:
On vehicles with
ABS
the brake service operations
described in the repair manual must be supplement-
ed by bleeding operations using the
BMW
MoDiTeC/DIS plus with the ABS control unit
toolbox.
Failure to use the
BMW
MoDiTeC/DIS plus results
in a hazard of residual air remaining in the ABS con-
trol circuits.
–
Add brake fluid until it reaches the top of the
sight glass
•
Connect the brake bleeding device to the bleed
screw on the brake caliper
•
[ABS]
Bleed vehicle with
BMW
MoDiTeC/DIS plus
•
Open the bleed screw by half a turn
e
Attention:
Brake fluid level must not drop below the MIN mark
during the bleeding process, otherwise air will be
drawn into the brake system. Bleed the system
again if this happens!
•
Extract brake fluid until it emerges clear and free
of air bubbles
•
Tighten the bleed screw
•
Check the operation of the brake system
Operating fluid:
Brake fluid .....................................................DOT 4
X
Torque specification:
Bleed screw ................................................. 14 Nm
Variator drive belt replacement
(Inspections II and III)
•
Remove fasteners (1)
•
Remove vent cover
•
Remove fasteners (2)
•
Remove variator cover
When installing:
•
Note positions of vent hose and bracket (arrow)
C1000240
1
C1000250
2