![background image](/i/bmw/160195/bmw-c1-2001/h/bmw-c1-2001-406.png)
61.14
•
Remove fasteners for control cable
•
Lift starter relay to the right and remove
When installing:
•
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following:
e
Attention:
Make sure all cables are reconnected to their origi-
nal terminals.
X
Torque specification:
Battery cable attachment ............................... 3 Nm
Control cable attachment ............................ 0.4 Nm
67 12 001
Removing and installing
wipe/wash pump and replacing fluid
reservoir
–
Remove front fairing panel
–
Swing the headlight forward and down
–
Remove sill centre section
a
....................................................See Group 46
•
Disconnect plug (2)
•
Disconnect filler hose (1)
•
Pull fluid reservoir up to remove
L
Note:
Fluid can escape from reservoir.
Hold the reservoir (3) upright to prevent the fluid
from leaking out!
•
Disconnect delivery hose (4)
•
Remove fluid reservoir (3) and drain if necessary
C1610111
C1610141
1
2
3
4