24

GB

Replacing the Triple ring burner nozzles

1.  Remove the pan supports and lift the burners out of their housing. The 

burner consists of two separate parts (see pictures).

2.  Unscrew the nozzles using a 7 mm socket spanner. Replace the nozzles 

with models that are configured for use with the new type of gas (see Table 

1). The two nozzles have the same hole diameter.

3.  Replace all the components by completing the above operations in reverse 

order.

•  Adjusting the burners’ primary air

Does not require adjusting.

•  Setting the burners to minimum

1.  Turn the tap to the low flame position;

2. Remove the knob and adjust the adjustment 

screw, which is positioned in or next to the tap 

pin, until the flame is small but steady.

3.  Having adjusted the flame to the required low setting, while the burner is 

alight, quickly change the position of the knob from minimum to maximum 

and vice versa several times, checking that the flame does not go out.

4.  Some appliances have a safety device (thermocouple) fitted. If the device 

fails to work when the burners are set to the low flame setting, increase 

this low flame setting using the adjusting screw.

5.  Once the adjustment has been made, replace the seals on the by-passes 

using sealing wax or a similar substance.

!

 If the appliance is connected to liquid gas, the regulation screw must be 

fastened as tightly as possible.

!

 Once this procedure is finished, replace the old rating sticker with one 

indicating the new type of gas used. Stickers are available from any of our 

Service Centres.

!

 Should the gas pressure used be different (or vary slightly) from the 

recommended pressure, a suitable pressure regulator must be fitted to the 

inlet pipe (in order to comply with current national regulations).

Electrical 

connections

DATA PLATE

see data plate

This appliance conforms to the following 

European Economic Community directives:

- 2006/95/EEC dated 12/12/06 (Low 

Voltage) and subsequent amendments

- 2004/108/EEC dated 15/12/04 

(Electromagnetic Compatibility) and 

subsequent amendments

- 93/68/EEC dated 22/07/93 and 

subsequent amendments.

- 2009/142/EEC dated 30/11/09 (Gas) and 

subsequent amendments.

- 2012/19/EC and subsequent 

amendments.