24
What is Multi Edit?
Pushing the Multi Edit button gives you access to 10 different editing parameters. (See the chart below)
1.
In the KIT screen, press [Button 2] (MULTI EDIT) .
The Multi Edit screen appears.
Here you can see all the relative values assigned to each pad and external trigger input.
The changes you make are saved in the kit. You can’t edit a kit whose “Kit Protect” (p. 34) is on.
Name of the
parameter you’re
editing
Indicates the pad you’re editing and will change when you
play a pad.
Value of each pad (Inst A is above, Inst B is below)
Values for external trigger inputs 1–4 (Head is above, Rim
is below)
Use [Knob 2] (B) to change the value of Inst B (Rim).
Use [Knob 3] (A) to change the value of Inst A (Head).
Press [Button 3] (ALL) to copy the current value to all pads
and external triggers.
Turn [Knob 1] (PARAM)
and a popup list
appears select a
parameter here.
2.
Turn [Knob 1] (PARAM) to select the parameter and press [Button 3] (OK) to confirm your choice .
Parameter
Value
Explanation
Tuning
-2400–+2400
Negative (“-”) values will lower the pitch; positive (“+”) values will raise the pitch. The value will change
in steps of 10 as you turn the knob.
Coarse Tune
-2400–+2400
This is the same as Tuning, but the value will change in steps of 100 as you turn the knob.
Muffling
0–50
Increasing the value will decrease the resonance and decay.
Soft Attack
0–50
Specifies the sharpness of the attack. Increasing the value will soften the sound’s attack.
Tone Color
L50–H50
Modifies the brightness of the sound. Higher settings will produce a brighter sound.
Pitch Sweep
-100–+100
Positive (“+”) settings will make the pitch change from high to low. Negative (“-”) settings will make the
pitch change from low to high.
Volume
0–100
Specifies the volume.
Pan
L15–CTR–R15
Specifies the pan position. CTR is center.
Reverse
OFF, ON
If this is ON, the pad’s sound will play backward.
*
Some Insts will NOT play in reverse .
FX Send
0–100 or OFF, ON
Determines the send level to FX (effect). Adjust accordingly.
3.
Hit a pad to select it for editing .
•
If you want to edit multiple pads at the same time, hold down [Button 1] (MULTISEL) and play the desired pads.
•
If you hit a pad that is not selected, it will cancel the multi selection.
To stay in this multi selection mode, only play the pads you have selected.
4.
Use [Knob 3] (A) or [Knob 2] (B) to edit the value .
•
[Knob 3] (A) changes the value for Inst A (Head).
•
[Knob 2] (B) changes the value for Inst B (Rim).
5.
Press the [BACK] button to return to the KIT screen .
If you want to adjust the pad’s sensitivity, refer to “Internal Pad Sensitivity Settings” (p. 59).
03
MULTI EDIT
