41

O

ver

view

Basic Oper

ation

Adv

. 1 (K

it)

Adv

. 2 (P

hr

ase)

Adv

. 3 (
O

ther)

A

ppendix

Using the Knobs to Control the FX (FX CONTROL)

You can use [Knob 1]–[Knob 3] to control FX parameters. For each FX, the most suitable parameters are automatically assigned 

to the three knobs.
Changes you make in the FX CONTROL screen are not saved to the kit.

1. 

Press the [FX CTRL] button .

The FX CONTROL screen appears.

MEMO

You can also access the FX CONTROL screen from the KIT screen by pressing [Button 3] (FX CTRL).

[Button 1] (SEND) 

moves to a screen 

where you can set 

the send level for 

each pad.

FX type

Pads for which FX is enabled.

[Knob 1–3] adjusts the effect parameters.

[Button 3] (BYPASS) temporarily turns FX off.

MEMO

When you’re recording a phrase loop (REC mode), knob movements are recorded on the phrase’s FX track. [Button 1] 

operates as TR MUTE; the FX track will be muted when you turn it on.

Adjusting the FX send level for each pad (FX CONTROL-FX SEND)

The FX SEND (FX send level) screen is also accessible from the FX CONTROL screen.

1. 

Press the [FX CTRL] button .

2. 

Then press [Button 1] (SEND) to enter the FX SEND (FX send level) screen .

Operations are as mentioned above p. 40.
Remember that any changes made via this page will NOT be saved to the kit. Movements or adjustments to send levels while in 

Rec mode of the phrase loop will NOT be recorded into the phrase.