Technical Reference for ZyXEL omni.net series
8-6
NOTE:
The omni.net LCD/LCD+M does not support network
independent clock compensation. The synchronous timing source
must be supplied by the omni.net LCD/LCD+M , which is phase
locked to the network synchronous clock.
When in V.25bis command mode, the omni.net LCD/LCD+M supports the bit-oriented HDLC
(High-Level Link Control) synchronous protocol which most synchronous communication links
use. Use
AT*Ii
to enable V.25bis commands. For synchronous applications the TA is set for use
with one application, in normal situations. Save the desired settings in the power-on profile and the
TA will start up in synchronous mode with V.25bis enabled. A special command set RST is
provided to get the TA back to asynchronous AT command mode from V.25bis mode.
When the TA is used as a DCE device with a router or mainframe system, use the following
command string for best results:
AT&S1&M3*I1&W0Z0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
