![background image](/i/bmw/160195/bmw-c1-2001/h/bmw-c1-2001-214.png)
24.22
When installing:
•
Install shaft oil seal with assembly press,
BMW No. 11 7 592
Replacing shaft oil seal for variator
shaft in gearbox cover
(shaft removed)
•
Uniformly chamfer collar at cover
e
Attention:
Deburr shaft oil seal seat - remove gratings
spray shaft oil seal seats!
•
Insert dry shaft oil seal with drift punch,
BMW No. 11 7 581
, continuing until it seats on
machined housing surface
e
Attention:
Make sure that shaft oil seal does not contact
grooved ball bearing - maintain specified gap!
e
Attention:
Install cover with new seal and tighten fasteners in
cross pattern!
When installing:
•
Install shaft oil seal with extruded edge seal on
the inside
Adjustment specification:
Gap.....................................................0.1…0.3 mm
................................................ (0.0004…0.0118 in)
Fluids and lubricants:
Shaft oil seal seats ............Klüber paste 46 MR 401
11 11 276 # Replacing grooved ball bearing for
variator shaft in gearbox cover
–
Remove complete variator assembly (
–
–
Remove shaft oil seal (
e
Attention:
To avoid damaging the joint surface use an old gas-
ket and support on blocks!
•
Press out grooved ball bearing with tube,
BMW No. 11 7 571
, D=32 mm (1.2598 in) or
24 mm (0.9449 in) socket into gearbox from the
outside
11 7 592
C1110740
11 7 601
11 7 581
C1110750
C1110760
11 7 571