![background image](/i/infiniti/153279/infiniti-g37-coupe-2009/h/infiniti-g37-coupe-2009-129.png)
PROGRAMMING HOMELINK
姞
FOR
CANADIAN CUSTOMERS
Prior to 1992, D.O.C. regulations required hand-
held transmitters to stop transmitting after 2
seconds. To program your hand-held transmit-
ter to HomeLink
姞
, continue to push and hold
the HomeLink
姞
button (note steps 2 through 4
under “Programming HomeLink
姞
”) while you
push and re-push (“cycle”) your hand-held
transmitter every 2 seconds until the indicator
light flashes rapidly (indicating successful pro-
gramming).
NOTE:
If programming a garage door opener, etc., it is
advised to unplug the device during the “cy-
cling” process to prevent possible damage to
the garage door opener components.
OPERATING THE HOMELINK
姞
UNIVERSAL TRANSCEIVER
HomeLink
姞
Universal Transceiver (once pro-
grammed) may now be used to activate the
garage door, etc. To operate, simply push the
appropriate programmed HomeLink
姞
Universal
Transceiver button. The red indicator light will
illuminate while the signal is being transmitted.
PROGRAMMING TROUBLE-DIAGNOSIS
If HomeLink
姞
does not quickly learn the hand-
held transmitter information:
●
replace the hand-held transmitter batteries
with new batteries.
●
position the hand-held transmitter with its
battery
area
facing
away
from
the
HomeLink
姞
surface.
●
push and hold both the HomeLink
姞
and
hand-held transmitter buttons without inter-
ruption.
●
position the hand-held transmitter 2 to 5 in
(50 to 127 mm) away from the HomeLink
姞
surface. Hold the transmitter in that position
for up to 15 seconds. If HomeLink
姞
is not
programmed within that time, try holding
the transmitter in another position - keeping
the indicator light in view at all times.
If you continue to have programming difficul-
ties, please contact the INFINITI Consumer Af-
fairs Department. The phone numbers are lo-
cated in the Foreword of this Owner’s Manual.
CLEARING THE PROGRAMMED
INFORMATION
Individual buttons cannot be cleared, however
to clear all programming, push and hold the two
outside buttons and release when the indicator
light begins to flash (in approximately 20
seconds).
2-58
Instruments and controls
췽
—
—
07/26/08—pattie
墍