![background image](/i/infiniti/153279/infiniti-g37-coupe-2009/h/infiniti-g37-coupe-2009-043.png)
6. After attaching the child restraint, test it
before you place the child in it. Push it
from side to side while holding the seat
near the LATCH attachment path. The
child restraint should not move more than
1 in (25 mm) from side to side. Try to tug
it forward and check to see if the belt
holds the restraint in place. If the re-
straint is not secure, tighten the belt as
necessary, or put the restraint in another
seat and test it again. You may need to try
a different child restraint. Not all child
restraints fit in all types of vehicles.
7. Check to make sure the child restraint is
properly secured prior to each use. If the
child restraint is loose, repeat steps 3
through 6.
Rear-facing
Follow these steps to install a rear-facing child
restraint using LATCH system:
1. Position the child restraint on the seat.
Always follow the child restraint manufac-
turer’s instructions.
Front-facing — step 6
SSS0638
Rear-facing (webbing-mounted) — step 2
SSS0648
1-26
Safety — Seats, seat belts and supplemental restraint system
췽
—
—
07/23/08—pattie
墍