![background image](/i/infiniti/153279/infiniti-g37-coupe-2009/h/infiniti-g37-coupe-2009-163.png)
Selecting the memorized position
1.
Automatic transmission models:
Move the selector lever to the P (Park)
position.
Manual transmission models:
Apply the parking brake.
2. Raise the seatback (Coupe).
3. Use one of the following methods to move
the driver’s seat, the outside mirrors and
the steering wheel.
●
Push the ignition switch to the ON posi-
tion and push the memory switch (1 or 2)
fully for at least 1 second.
●
Within 45 seconds of opening the driver’s
door, push the memory switch (1 or 2)
fully for at least 1 second.
The driver’s seat, steering column and
outside mirrors will move to the memo-
rized position with the indicator light
flashing, and then the light will stay on for
approximately 5 seconds.
For manual transmission models, the memory
positions can be selected even when the engine
is running. In this case, move the shift lever to
the N (Neutral) position and apply the parking
brake. Then, perform step 2.
SYSTEM OPERATION
The automatic drive positioner system will not
work or will stop operating under the following
conditions:
●
When the vehicle speed is above 4 MPH (7
km/h).
●
When the adjusting switch for the driver’s
seat and steering column is turned on while
the automatic drive positioner is operating.
●
When the memory switch 1 or 2 is not
pushed for at least 1 second.
●
When the seat, steering column and outside
mirrors have already been moved to the
memorized position.
●
When no position is stored in the memory
switch.
●
When the parking brake is released (MT
models).
●
When the speed is above 4 MPH (7 km/h)
while the parking brake is applied (MT mod-
els).
To restart the drive positioner system, move
the parking brake to off and on.
●
When the engine is started while moving the
automatic drive positioner.
●
When the AT selector lever is moved from the
P (Park) position to any other position. (How-
ever, it will not be canceled if the switch is
pushed while the seat and steering column
are returning to the previous positions
(entry/exit function).)
●
When the driver’s door remains open for
more than 45 seconds and the ignition
switch is not in the ON position.
●
When the seatback is folded (Coupe).
●
While the walk-in function operates (Coupe).
●
The seat synchronization function is auto-
matically disabled if the outside mirrors or
steering wheel reaches its maximum adjust-
ment.
●
The seat synchronization function will not
move if the seat is adjusted over one of the
following maximum thresholds:
– Seat sliding: 3.0 in (76 mm)
– Seatback reclining: 9.1 degrees
– Seat lifter (rear side): 0.8 in (20 mm)
3-32
Pre-driving checks and adjustments
췽
—
—
08/01/08—tbrooks
墍