![background image](/i/infiniti/153279/infiniti-g37-coupe-2009/h/infiniti-g37-coupe-2009-336.png)
WARNING
Always follow the instructions below. Failure to
do so could result in damage to the charging
system and cause personal injury.
1. If the booster battery is in another vehicle
䊊
A
, position the two vehicles (
䊊
A
and
䊊
B
)
to bring their batteries into close proxim-
ity to each other.
Do not allow the two vehicles to touch.
2. Apply parking brake. Move the selector
lever to the P (Park) position (Automatic
transmission models). Move the shift le-
ver to the N (Neutral) position (Manual
transmission models). Switch off all un-
necessary
electrical
systems
(light,
heater, air conditioner, etc.).
3. Remove vent caps on the battery (if so
equipped). Cover the battery with a firmly
wrung out moist cloth
䊊
C
to reduce explo-
sion hazard.
4. Connect jumper cables in the sequence as
illustrated (
䊊
1
→
䊊
2
→
䊊
3
→
䊊
4
).
If the battery is disconnected or discharged,
the steering wheel will lock and cannot be
turned. Supply power using jumper cables
before pushing the ignition switch and dis-
engaging the steering lock.
CAUTION
●
Always connect positive (+) to positive (+)
and negative (
⫺
) to body ground (as illus-
trated) — not to the battery.
●
Make sure the jumper cables do not touch
moving parts in the engine compartment and
that clamps do not contact any other metal.
5. Start the engine of the booster vehicle
䊊
A
and let it run for a few minutes.
6. Keep the engine speed of the booster
vehicle
䊊
A
at about 2,000 rpm, and start
the engine of the vehicle being jump
started
䊊
B
.
SCE0653
In case of emergency
6-9
췽
—
—
07/26/08—pattie
墍