36

Automatic Image Transfer After Each Shot

To transfer smaller JPEGs when the camera is set up to record larger JPEGs to one card 
and smaller JPEGs to the other, set [

JPEG size to trans.

] to [

Smaller JPEG

]. 

To transfer either RAW or JPEG images when the camera is set up to record RAW images 
to one card and JPEGs to the other, specify which images to transfer in the [

RAW+JPEG 

transfer

] setting. Similarly, complete the same setting when RAW+JPEG images are 

recorded simultaneously to a single memory card.

When images of the same size are recorded to both cards simultaneously, images recorded 
to the CF card are transferred, regardless of image quality (compression). 

If transfer fails, an error number is displayed on the 
transmitter’s LCD panel, and the <

LAN

> lamp blinks in 

red. 
In this case, see page 98 to eliminate the cause of the 
error. 
Once the cause of the error is eliminated, the images 
whose transfer previously failed will be transferred 

automatically. With this option activated, transfer is attempted again automatically after failure, 
both when shooting with automatic transfer and when transferring captured images via FTP. 
Note that when you cancel image transfer, or turn off the transmitter or camera, the image will 
not be re-transferred automatically. See page 40 and transfer the image manually.

In the menu, select [

Communication settings

] 

 [

Network settings

] 

 [

Set up

] 

[

LAN power save

].

When this option is set to [

Enable

], the transmitter will log off from the FTP server after 

transfer and switch to standby mode. Wireless and wired connectivity will be restored 
automatically when you attempt to transfer images, and the transmitter will reconnect to the 
FTP server.

Auto Retry if Transfer Fails

Enabling LAN Power Management

COP

Y