26
Operation and settings
Default: Click this button to restore the IP device back to
•
original factory settings.
Stream
Master/Slave
Enable: Click to activate the stream function.
>
Deinterlacing: Click to enable the use of deinterlac
-
>
ing function.
Video codec: Select the video mode (Codec) from
>
the drop-down list. The viewer can choose between
MJPEG and H.264.
Resolution: Select the image size to be sent from the
>
camera.
NTSC:
D1 (704 x 480), HALF D1 (704 x 240),
CIF (352 x 240) and QCIF (176 x 112)
PAL:
D1 (704 x 576), HALF D1 (704 x 288),
CIF (352 x 288) and QCIF (176 x 144)
Maximum frame rate: Set the frame rate of the
>
image. Selectable values of the frame rates are as
follows.
NTSC:
1 to 30 (fps)
PAL:
1 to 25 (fps)
GOP size: It means “Group of Pictures”. The higher the
>
GOP, the better is the video quality of the camera.
Edit the value of GOP from 1 to 30. This setting is
valid for H.264 video format only.
Quality: Select the Quality.
>
VBR: The bit rate may vary depending on the
-
complexity of the video to meet the selected
quality.
CBR: The video quality may vary in order to pre
-
-
serve a constant bit rate.
Stream quality: If the [Quality] option set to VBR, this
>
option is displayed. Select the stream quality from
the drop down box, the camera supports five types
(Highest, High, Medium, Low and Lowest)
Bit rate: If the [Quality] option set to CBR, this option
>
is displayed. Edit the bit rate value from 64 kbps to
10 240 kbps.
Save: Click this button to confirm the settings.
•
