Replacing consumable items > 48

R

EPLACING

THE

 T

RANSFER

BELT

UNIT

The belt unit is located under the four image drums. This unit requires replacement 

approximately every 60,000 pages.
Switch off the printer and allow the fuser to cool for about 10 minutes before opening the 

cover.

1.

Press the cover release and open the printer’s top cover fully.

2.

Note the positions of the fo

ur toner cartridges (a) and image drums (b). It is e

ssential 

that they go back in the same order.

3.

Lift each of the image drum units out of the printer and place them in a safe place 

away from direct sources of heat and light.

WARNING!

If the printer has been powered on, the fuser will be hot. This area 

is clearly labelled. Do not touch.

CAUTION!

The green image drum surface at the base of each cartridge is very 

delicate and light sensitive. Do not touch it and do not expose it to 

normal room light for more than 5 minutes. If the drum unit needs 

to be out of the printer for longer than this, please wrap the 

cartridge inside a black plastic bag to keep it away from light. 

Never expose the drum to direct sunlight or very bright room 

lighting.

a

b