Clearing paper jams > 66

Holding the complete assembly by its top centre, lower it into place in the printer, 

locating the pegs at each end into their slots in the sides of the printer cavity.

9.

Lower the top cover but do not press down to latch it closed yet. This will protect the 

drums from excessive exposure to room lighting while you check the remaining 

areas for jammed sheets.

10.

Open the rear exit tray (a) and check for a sheet of paper in the rear path area (b).

>

Pull out any sheets found in this area.

>

If the sheet is low down in this area and difficult to remove, it is probably still 

gripped by the fuser. In this case raise the top cover, reach around and press 

down on the fuser pressure release lever (a).

11.

If you are not using the rear exit tray, close it once any paper has been removed 

from this area.

12.

If a duplex unit is fitted, lift lever (a) and lower the duplex unit cover and pull out 

any sheets found in this area. Close the duplex unit cover

a

b

a

a