Clearing paper jams > 64

7.

Look into the printer to check whether any sheets of paper are visible on any part of 

the belt unit.

(a)

To remove a sheet with its leading edge at the front of the belt (1), carefully lift 

the sheet from the belt and pull it forwards into the internal drum cavity and 

withdraw the sheet.

(b)

To remove a sheet from the central area of the belt (2), carefully separate the 

sheet from the belt surface and withdraw the sheet.

(c)

To remove a sheet just entering the fuser (3), separate the trailing edge of the 

sheet from the belt, push the fuser pressure release lever (4) towards the front 

and down to release the fuser’s grip on the sheet, and withdraw the sheet 

through the drum cavity area. Then allow the pressure release lever to rise 

again.

CAUTION!

Do not use any sharp or abrasive objects to separate sheets from 

the belt. This may damage the belt surface.

NOTE:
If the sheet is well advanced into the fuser (only a short length is still visible), 
do not attempt to pull it back. Follow the next steps.

4

2

3

1