ML1120/ML1190 User’s Guide – Operating instructions > 56

A

DJUSTING

 TOF 

POSITION

Use the following procedure to set TOF to accord with the 
reference position (6.35 mm (0.25 in)). The reference position 
refers to the first line of the paper i.e. the position to which the 
printer feeds the paper when automatically loading the paper.

1.

Print out the menu settings of the printer as in 

“Confirming current settings” on page 45

 and confirm that 

the TOF (in cut sheet mode or continuous forms mode) is 
6.35 mm (0.25 in).

2.

Set the Paper Type lever to the required paper type.

3.

When continuous forms are used, place the paper on the 
Pin Tractor.

For cut sheet mode, do not insert the paper at this stage.

4.

In continuous forms mode, press the LOAD/EJECT button.

In cut sheet mode, place the paper in the Paper Tray and 
press LOAD/EJECT.

As the paper is taken into the printer, press the LF/FF 
button and the paper is taken into the 6.35 mm (0.25 in) 
position.

5.

In off-line mode, press the following buttons to adjust the 
first printing line:

To feed the paper forward by a small amount, press and 
hold down the LOAD/EJECT button and then press the SEL 
button.

To feed the paper backward by a small amount, press and 
hold down the LOAD/EJECT button and then press the LF/
FF button.

NOTE
Adjusting of TOF can be done in cut sheet mode or continuous 
forms mode.

NOTE
If the specified correction range is more than +- 0.366 mm 
(1/144 in), the QUIET indicator flashes and the paper cannot 
be moved.