MediaSuite xxHFL5573D/10
Page 39
E
n
g
lis
h
Reinstall TV
Starts a TV initialization to reset all
settings to default and replace (reinstall)
all channels.
1. Press
[Home/Menu] ] > [TV Setup>
[OK]
.
2. Select
[Setup] > [TV settings] >
[Reinstall TV],
then press
OK
.
TV will perform a power down cycle going
into standby and then starts-up again. If
the TV stays in Standby mode, wake TV
up with switch on button on remote
control.
1.
Region
OSD is displayed:
Region
Australia
Europe
Select
[Europe]
and press
<OK>
.
2. Select language OSD is displayed:
Select
[xxxx]
(i.e. language from list)
and
press
<OK>
.
3. Select install country OSD is
displayed:
Select
[xxxx]
(i.e. country from list)
and
press
<OK>
.
4.
Select
TV placement OSD is
displayed:
[Wall mounted]:
in case of
wall
mounting
[On a TV stand]
:
in
case
of
stand
and press
<OK>
.
5.
Universal
access for the visual
and hearing impaired OSD is
displayed:
[No]
:
No special settings
[Yes]:
Special
settings
configured
and
press
<OK>
.
6.
Press
[Settings]
to continue and
install channels.
Perform
the following steps:
[
Install TV channels]
and
press
<OK>
[
Continue
]
[Settings]
A
screen
is displayed to make changes to
set the channel list/map configuration:
[Symbol rate mode]:
Automatic
TV will use the
preset Symbol rate
(6.900/6.875)
Manual
Option to set
Symbol rate 1 and
Symbol rate 2
[Symbol rate 1]:
0.000 (to set)
[Symbol rate 2]:
0.000 (to set)
[Frequency scan]
:
Quick scan
Install channels
based on a pre-
configured data
table
Full scan
Install channels
based on scanning
the whole
frequency spectrum
[Frequency step]
:
1 MHz
With Full scan, step
size to search for
channels is 1 MHz
8 MHz
With Full scan, step
size to search for
channels is 8 MHz
