Chapter 13 Spanning Tree Protocol
GS2210 Series User’s Guide
123
13.7 Multiple Rapid Spanning Tree Protocol Status
Click Advanced Application > Spanning Tree Protocol in the navigation panel to display the
status screen as shown next. See
for more information on MRSTP.
Note: This screen is only available after you activate MRSTP on the Switch.
Figure 91
Advanced Application > Spanning Tree Protocol > Status: MRSTP
The following table describes the labels in this screen.
Path Cost
Path cost is the cost of transmitting a frame on to a LAN through that port. It is
recommended to assign this value according to the speed of the bridge. The slower the
media, the higher the cost-see
for more information.
Tree
Select which STP tree configuration this port should participate in.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Table 47
Advanced Application > Spanning Tree Protocol > MRSTP (continued)
LABEL
DESCRIPTION
Table 48
Advanced Application > Spanning Tree Protocol > Status: MRSTP
LABEL
DESCRIPTION
Configuration
Click Configuration to specify which STP mode you want to activate. Click MRSTP to
edit MRSTP settings on the Switch.
Tree
Select which STP tree configuration you want to view.
Bridge
Root refers to the base of the spanning tree (the root bridge). Our Bridge is this switch.
This Switch may also be the root bridge.
Bridge ID
This is the unique identifier for this bridge, consisting of bridge priority plus MAC address.
This ID is the same for Root and Our Bridge if the Switch is the root switch.
Hello Time
(second)
This is the time interval (in seconds) at which the root switch transmits a configuration
message. The root bridge determines Hello Time, Max Age and Forwarding Delay.