Chapter 8 Basic Setting
GS2210 Series User’s Guide
65
Figure 46
Basic Setting > Switch Setup
The following table describes the labels in this screen.
Table 12
Basic Setting > Switch Setup
LABEL
DESCRIPTION
VLAN Type
Choose 802.1Q or Port Based. The VLAN Setup screen changes depending on whether
you choose 802.1Q VLAN type or Port Based VLAN type in this screen. See
MAC Address Learning: MAC address learning reduces outgoing broadcast traffic.
Aging Time
Set the duration of time interval (from 30 to 65536) in seconds; the default is 300 seconds.
ARP Aging Time
Aging Time
Set the duration of time interval (from 30 to 65536) in seconds; the default is 300 seconds.
GARP Timer: Switches join VLANs by making a declaration. A declaration is made by issuing a Join message
using GARP. Declarations are withdrawn by issuing a Leave message. A Leave All message terminates all
registrations. GARP timers set declaration timeout values. See the chapter on VLAN setup for more
background information.
Join Timer
Join Timer sets the duration of the Join Period timer for GVRP in milliseconds. Each port has
a Join Period timer. The allowed Join Time range is between 100 and 65535 milliseconds;
the default is 200 milliseconds. See the chapter on VLAN setup for more background
information.
Leave Timer
Leave Time sets the duration of the Leave Period timer for GVRP in milliseconds. Each port
has a single Leave Period timer. Leave Time must be two times larger than Join Timer;
the default is 600 milliseconds.
Leave All Timer
Leave All Timer sets the duration of the Leave All Period timer for GVRP in milliseconds.
Each port has a single Leave All Period timer. Leave All Timer must be larger than Leave
Timer.