Chapter 35 DHCP
GS2210 Series User’s Guide
293
35.5.1 DHCPv4 VLAN Port Configure
Use this screen to apply a different DHCP option 82 profile to certain ports in a VLAN. To open this
screen, click IP Application > DHCP > DHCPv4 > VLAN > Port.
Figure 211
IP Application > DHCP > DHCPv4 > VLAN > Port
The following table describes the labels in this screen.
Delete
Select the configuration entries you want to remove and click Delete to remove them.
Cancel Click
Cancel to clear the Delete check boxes.
Table 142
IP Application > DHCP > DHCPv4 > VLAN (continued)
LABEL
DESCRIPTION
Table 143
IP Application > DHCP > DHCPv4 > VLAN > Port
LABEL
DESCRIPTION
VID
Enter the ID number of the VLAN you want to configure here.
Port
Enter the number of port(s) to which you want to apply the specified DHCP option 82
profile.
You can enter multiple ports separated by (no space) comma (,) or hyphen (-). For
example, enter “3-5” for ports 3, 4, and 5. Enter “3,5,7” for ports 3, 5, and 7.
Option 82
Profile
Select a pre-defined DHCP option 82 profile that the Switch applies to the specified port(s)
in this VLAN. The Switch adds the Circuit ID sub-option and/or Remote ID sub-option
specified in the profile to DHCP requests that it relays to a DHCP server.
The profile you select here has priority over the one you select in the DHCP > DHCPv4 >
VLAN screen.
Add
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes
if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel
Click this to reset the values above based on the last selected entry or, if not applicable, to
clear the fields above.
Clear
Click Clear to reset the fields to the factory defaults.
Index
This field displays a sequential number for each entry. Click an index number to change the
settings.
VID
This field displays the VLAN to which the port(s) belongs.