Chapter 8 Basic Setting
GS2210 Series User’s Guide
82
8.10.7 IPv6 Neighbor Discovery Setup
Use this screen to configure neighbor discovery settings for each interface. Click the link next to
IPv6 Neighbor Discovery Setup in the IPv6 Configuration screen to display the screen as
shown next.
Figure 60
Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Discovery Setup
The following table describes the labels in this screen.
Interface
This is the name of the IPv6 interface you created.
IPv6 Global
Address/Prefix
Length
This field displays the IPv6 global address and prefix length for the interface.
EUI-64
This shows whether the interface ID of the global address is generated using the EUI-64
format.
Delete
Check the entry(ies) that you want to remove in the Delete column and then click Delete to
remove the selected entry(ies) from the summary table.
Cancel
Click Cancel to clear the Delete check boxes.
Table 24
Basic Setting > IPv6 > IPv6 Configuration > IPv6 Global Address Setup (continued)
LABEL
DESCRIPTION
Table 25
Basic Setting > IPv6 > IPv6 Configuration > IPv6 Neighbor Discovery Setup
LABEL
DESCRIPTION
Interface
Select the IPv6 interface you want to configure.
DAD Attempts
The Switch uses Duplicate Address Detection (DAD) with neighbor solicitation and
advertisement messages to check whether an IPv6 address is already in use before assigning
it to an interface, such as the link-local address it creates through stateless address
autoconfiguration.
Specify the number of consecutive neighbor solicitations (from 0 to 600) the Switch sends for
this interface. Enter 0 to turn off DAD.
NS Interval
Specify the time interval (from 1000 to 3600000 milliseconds) at which neighbor solicitations
are re-sent for this interface.
Reachable
Time
Specify how long (from 1000 to 3600000 milliseconds) a neighbor is considered reachable for
this interface.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the nonvolatile memory when you are done configuring.