Chapter 8 Basic Setting
GS2210 Series User’s Guide
80
The following table describes the labels in this screen.
8.10.5 IPv6 Link-Local Address Setup
A link-local address uniquely identifies a device on the local network (the LAN). It is similar to a
“private IP address” in IPv4. You can have the same link-local address on multiple interfaces on a
device. A link-local unicast address has a predefined prefix of fe80::/10.
Use this screen to configure the interface’s link-local address and default gateway. Click the link
next to IPv6 Link-Local Address Setup in the IPv6 Configuration screen to display the screen
as shown next.
Figure 58
Basic Setting > IPv6 > IPv6 Configuration > IPv6 Link-Local Address Setup
The following table describes the labels in this screen.
Table 22
Basic Setting > IPv6 > IPv6 Configuration > IPv6 Interface Setup
LABEL
DESCRIPTION
Interface
Select the IPv6 interface you want to configure.
Active
Select this option to enable the interface.
Address
Autoconfig
Select this option to allow the interface to automatically generate a link-local address via
stateless autoconfiguration.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the nonvolatile memory when you are done configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Clear
Click Clear to reset the fields to the factory defaults.
Index
This is the interface index number. Click on an index number to change the settings.
Interface
This is the name of the IPv6 interface you created.
Active
This field displays whether the IPv6 interface is activated or not.
Address
Autoconfig
This field displays whether stateless autoconfiguration is enabled on the interface.
Table 23
Basic Setting > IPv6 > IPv6 Configuration > IPv6 Link-Local Address Setup
LABEL
DESCRIPTION
Interface
Select the IPv6 interface you want to configure.
Link-Local
Address
Manually configure a static IPv6 link-local address for the interface.
Default
Gateway
Set the default gateway IPv6 address for the interface. When an interface cannot find a
routing information for a frame’s destination, it forwards the packet to the default gateway.