Chapter 7 ZON Utility, ZON Neighbor Management and Port Status
GS2210 Series User’s Guide
56
The following table describes the labels in this screen.
7.4.1 Status: Port Details
Click a number in the Port column in the Status screen to display individual port statistics. Use this
screen to check status and detailed performance data about an individual port on the Switch.
Table 8
Status
LABEL
DESCRIPTION
Port
This identifies the Ethernet port. Click a port number to display the Port Details screen
(refer to
).
Name
This is the name you assigned to this port in the Basic Setting > Port Setup screen.
Link
This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps or 1000M for
1000Mbps) and the duplex (F for full duplex or H for half). It also shows the cable type
(Copper or Fiber) for the combo ports.
State
If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port. See
(
for more information)
If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it displays
STOP.
PD
For PoE model(s) only
This field displays whether or not a powered device (PD) is allowed to receive power from
the Switch on this port.
LACP
This fields displays whether LACP (Link Aggregation Control Protocol) has been enabled on
the port.
TxPkts
This field shows the number of transmitted frames on this port.
RxPkts
This field shows the number of received frames on this port.
Errors
This field shows the number of received errors on this port.
Tx KB/s
This field shows the number of kilobytes per second transmitted on this port.
Rx KB/s
This field shows the number of kilobytes per second received on this port.
Up Time
This field shows the total amount of time in hours, minutes and seconds the port has been
up.
Clear Counter
Enter a port number and then click Clear Counter to erase the recorded statistical
information for that port, or select Any to clear statistics for all ports.