Chapter 8 Basic Setting
GS2210 Series User’s Guide
74
Figure 52
Basic Setting > Interface Setup
The following table describes the labels in this screen.
8.10 IPv6
Use this screen to view the IPv6 interface status and configure Switch’s management IPv6
addresses.
Click Basic Setting > IPv6 in the navigation panel to display the IPv6 status screen as shown
next.
Table 17
Basic Setting > Interface Setup
LABEL
DESCRIPTION
Interface Type Select the type of IPv6 interface for which you want to configure. The Switch supports the
VLAN interface type for IPv6 at the time of writing.
Interface ID
Specify a unique identification number (from 1 to 4094) for the interface.
To have IPv6 function properly, you should configure a static VLAN with the same ID number
in the Advanced Application > VLAN screens.
Add
Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses these changes if
it is turned off or loses power, so use the Save link on the top navigation panel to save your
changes to the non-volatile memory when you are done configuring.
Cancel
Click Cancel to reset the fields to your previous configuration.
Index
This field displays the index number of an entry.
Interface Type This field displays the type of interface.
Interface ID
This field displays the identification number of the interface.
Interface
This field displays the interface’s descriptive name which is generated automatically by the
Switch. The name is from a combination of the interface type and ID number.
Delete
Click Delete to remove the selected entry from the summary table.
Cancel Click
Cancel to clear the Delete check boxes.