Chapter 32 Link Layer Discovery Protocol (LLDP)
GS2210 Series User’s Guide
270
32.7 LLDP-MED Configuration
Click Advanced Application > LLDP > LLDP-MED Configuration (Click Here) to display the
screen as shown next.
Figure 193
Advanced Application > LLDP > LLDP-MED Configuration
The following table describes the labels in this screen.
Apply
Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel
Click Cancel to begin configuring this screen afresh.
Table 126
Advanced Application > LLDP > LLDP Configuration > Org-specific TLV Setting
LABEL
DESCRIPTION
Table 127
Advanced Application > LLDP > LLDP-MED Configuration
LABEL
DESCRIPTION
Port
This displays the port number on which you’re configuring LLDP-MED. Select * to
configure all ports simultaneously.
Notification
Topology
Change
Select to enable LLDP-MED topology change traps on this port.
MED TLV Setting
Location
Select to enable transmitting LLDP-MED location TLV.
Network Policy
Select to enable transmitting LLDP-MED Network Policy TLV.
Apply
Click Apply to save the changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel
Click Cancel to begin configuring this screen afresh.