HOW TO MAKE COPIES
- 35 -
1
2
3
4
5
6
Bypass Copying
When you make copies on OHP film, sticker labels, envelopes
or non-standard size paper, place the copy paper on the multi-
purpose tray (MPT). Bypass copying is also recommended for
copying on standard size paper which is not set in any of the
trays.
Memo
• If you select the paper size, you can utilize various functions
such as the automatic paper selection (APS) or the
automatic magnification selection (AMS). For details, see
the following Guide:
Advanced Guide
Open the multi-purpose tray for bypass copying.
If the paper is large, pull out the paper holder.
When placing copy paper, open the paper set cover then adjust
the manual feeding paper guide.
If thick paper cannot be fed, printing takes a long time after
feeding or the quality is poor, turn over the paper and place it
again as shown in the figure or place fewer sheets.
The operating procedure for bypass copying differs depending
on the paper size to be used. See the table below for the
operating procedure of each size.
Memo
• Bypass copying stops when the paper placed on the multi-
purpose tray (MPT) runs out during copying, even if the
paper of the same size is in any of the trays. Copying
restarts when paper is supplied to the multi-purpose tray
(MPT).
• When bypass copying has been completed, the [RESET]
button on the control panel blinks. Press this button to
switch bypass copying to normal copying using the trays.
• (Even if you do not press the [RESET] button, the bypass
copying mode will be cleared when the automatic function
clear mode kicks in after a specified period of time.)
Current face down/up stacker
Face down/up stacker
auto-selection indication
[OUTPUT BIN] button
Paper size
Procedure
Standard size
Other than
North America:
A4, A5, B5
North America:
Letter, Legal
Other than the
above
the above standard sizes of
paper"
Envelope
Others (Non-standard sizes)
