SENDING/RECEIVING A FAX
- 61 -
1
2
3
4
5
6
Placing the original(s) on the RADF
This section describes how to set the original(s) on the RADF
(Reversing Automatic Document Feeder). When the originals
are placed on the RADF, the uppermost page is the first to be
scanned and sent.
• When scanning the duplex original with the RADF, do
not put your hand on the RADF. Paper may damage the
hand.
• When scanning the duplex original with the RADF, do
not put an object on the RADF. This could cause a paper
misfeed.
1
After aligning the originals, place them with
their face up and slide the guides to rest
against the edges of the originals.
• Regardless of their sizes, originals are acceptable up
to 100 sheets (35 to 80 g/m
2
(9.3 to 20 lb.)) or 16 mm
(0.62") in height.
• 2-sided originals can be set and sent.
Advanced Guide
• When an original of any size other than A4/Letter is
placed in the direction shown in the upper figure,
transmission to a recipient is carried out so that the
pre-entered sender information is printed in position A
in the figure.
• When an original of A4/Letter size is placed in the
direction shown in the lower figure, transmission to a
recipient is carried out so that the pre-entered sender
information is printed in position B in the figure.
• The pre-entered sender information shows what is
registered in the Terminal ID.
Advanced Guide
Sending different size originals
You can set different size originals together, using the RADF
(Reversing Automatic Document Feeder). Available
combinations of the original size are as follows.
• Other than North America: A4, FOLIO
• North America: Letter, Legal
Memo
• To send different size originals, you need to enable “MIXED
ORIGINAL SIZES” as a transmission condition.
P.62 "Setting the transmission conditions"
Precautions for using the RADF
Do not use the following originals as they may misfeed or
become damaged:
The following originals should be handled carefully:
A
B
(1) Badly wrinkled or folded originals. In
particular, originals whose leading edge
are curled may fail to be fed.
(4) Clipped or stapled originals
(2) Originals with carbon paper
(5) Originals with holes or torn originals
(3) Taped, pasted or clipped (cut out)
originals
(6) Damp originals (7) OHP film originals
(1) Folded or curled originals should be smoothed out
before being used.
(2) Originals sticking to each other, or originals that are
surface-treated may fail to separate properly.
