HOW TO MAKE COPIES

- 40 -

1

2

3

4

5

6

6

Press the button of the same size as the 

envelope you placed on the multi-purpose 
tray.

The size of the selected envelope will be registered as an 
“OTHER” size.

7

Press [OTHER] under “COPY”.

The paper size is now set to the size of the envelope 
placed on the multi-purpose tray. The paper type is 
automatically set to [ENVELOPE].

8

Select other copy modes as required, and 
then press the [START] button on the 
control panel.

Copying starts.
When the Inner Finisher is installed, the envelope exits to 
the receiving tray of the finisher.

Note

• Every 10 copies, take the envelopes out from the face 

down/up stacker.

Bypass copying on non-standard size 
paper

You can use non-standard size paper within the sizes shown 
on the right.

1

Place the original on the original glass.

2

Place the paper with its copy side face up 
on the multi-purpose tray. 

Note

• The height of the paper must not exceed the indicator 

on the side guides.

• When you use more than one sheet of paper, fan the 

sheets well before placing them on the multi-purpose 
tray. Be careful not to cut your fingers when fanning.

• Do not push paper into the entrance of the multi-

purpose tray (MPT). This could cause a paper misfeed.

3

Open the paper set cover, then Align the 
manual feeding paper guides to the paper 
length, and close the paper set cover.

"Zoom" screen is automatically displayed.

64 - 216 mm

127 - 356 mm

1

2