1

2

3

4

5

6

BASIC COPY MODES

- 43 -

●

BASIC COPY MODES

Before Using Copying Functions

Default settings

This equipment is under its “default settings” when the power is 
turned ON, namely, if no setting change has been applied yet, 
the equipment’s settings return to the default ones when the 
energy saving mode is cleared or the [RESET] button on the 
control panel is pressed. The default settings for basic copy 
modes at installation are shown below.

The default settings are changeable.

Confirming the set functions

If you press [SETTINGS] on the touch panel, the menu shown 
below is displayed. On this menu, you can view the functions 
that are currently set.

Switching to the function setting menu

To change the functions on the current menu, press the 
corresponding buttons. The desired setting menu will then 
appear.

Clearing the set functions

If you want to clear any copy function setting, press [RESET] 
on the corresponding setting menu.

Clearing all settings changed

When you press the [RESET] button on the control panel, all 
the function changes will be cleared.
Even if you do not do so, the changes will be cleared if the 
equipment is left idle for 45 sec. (default setting).

Restrictions on function combinations

Several copy functions can be used together. However some 
functions may not be used with other ones. For details, see the 
following Guide:



Advanced Guide

Item

Default setting

Reproduction ratio

100%

Copy quantity

1

Paper selection

Automatic Paper Selection 
(APS)

Simplex/Duplex

1-sided original -> 1-sided copy

Density adjustment

Automatic adjustment

Original mode

TEXT/PHOTO

Finishing mode

When using the original glass:

NON-SORT NON-STAPLE

When using the RADF 
(Reversing Automatic Document 
Feeder):

SORT

Feeding mode when using the 
RADF

Continuous feed mode