5.
2
Maintenance
Adjusting Shading
The scanning unit becomes dirty, it can alter the shading value. If your
print has black lines or is blurred, adjust the shading setting. Take the
following steps:
1. Load a sheet of white paper into the document feeder.
2. Press
Setup
on the front panel.
The display shows the first setup menu; FAX NUMBER/NAME.
3. Press
➛
or
❿
until ‘MAINTENANCE’ appears,then press
Start/Enter
.
The display shows the first menu; CLEAN DRUM.
4. Press
➛
or
❿
until you find ‘ADJUST SHADING’, then press
Start/Enter
.
The white paper is scanned through the document feeder.
Cleaning the OPC Drum
If you are getting streaks or spots on your print, you may clean the OPC
drum.
1. Make sure that the paper is loaded in the automatic input tray.
2. Press
Setup
on the control panel.
The display shows the first setup menu; FAX NUMBER/NAME.
3. Press
➛
or
❿
until ‘MAINTENANCE’ appears, then press
Start/Enter
.
4. The display shows the first menu, ‘CLEAN DRUM’, then press
Start/Enter
.
The machine automatically pulls in a sheet of paper, and prints it out.
The toner particles on the OPC drum surface are fixed to the paper.
5. Press
Stop
to return to Standby mode.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
