Table 2-2

  Jetdirect menus (continued)

Menu item

Sub-menu item

Sub-menu item

Values and Description

802.1X

Reset 

802.1X

 settings to factory defaults.

No

 (default): Retain current 

802.1X

 settings.

Yes

: Reset 

802.1X

 settings to factory defaults.

Enable Wipe

Most configuration settings are erased during a cold
reset. However, you can indicate whether to also
erase stored digital certificates.

Yes

: Erase all stored digital certificates during a cold

reset.

No

 (default): Do not erase stored digital certificates

during a cold reset.

Reset Security

Specify whether the current security settings on the
Jetdirect server will be saved or reset to factory
defaults.

No

 (default): The current security settings are

maintained.

Yes

: Security settings are reset to factory defaults.

Link Speed

The link speed and communication mode of the
Jetdirect server must match the network. The
available settings depend on the product and
installed Jetdirect server. Select one of the following
link configuration settings:

CAUTION:

If you change the link setting, network

communications with the Jetdirect server and
network product might be lost.

Auto

 (default): The Jetdirect server uses auto-

negotiation to configure itself with the highest link
speed and communication mode allowed. If auto-
negotiation fails, either the 

100TX Half

 value or the

10T Half

 value is set depending on the detected link

speed of the hub/switch port. (A 1000T half-duplex
selection is not supported.)

10T Half

: 10 Mbps, half-duplex operation.

10T Full

: 10 Mbps, full-duplex operation.

100TX Half

: 100 Mbps, half-duplex operation.

100TX Full

: 100 Mbps, full-duplex operation.

100TX Auto

: Limits auto-negotiation to a maximum

link speed of 100 Mbps.

1000T Full

: 1000 Mbps, full-duplex operation.

16

Chapter 2   Control panel