![background image](/i/infiniti/153108/infiniti-m56-2011/h/infiniti-m56-2011-129.png)
1. To begin, push and hold the 2 outer
HomeLink
姞
buttons (to clear the memory)
until the indicator light
䊊
A
blinks (after 20
seconds). Release both buttons.
2. Position the end of the hand-held trans-
mitter
1-3
inches
away
from
the
HomeLink
姞
surface.
3. Using both hands, simultaneously push
and hold both the HomeLink
姞
button you
want to program and the hand-held trans-
mitter button.
DO NOT release the buttons until step 4
has been completed.
4. Hold down both buttons until the indica-
tor light on HomeLink
姞
flashes, changing
from a “slow blink” to a “rapid blink”.
This could take up to 90 seconds. When
the indicator light blinks rapidly, both
buttons may be released. The rapidly
flashing light indicates successful pro-
gramming. To activate the garage door or
other programmed device, push and hold
the programmed HomeLink
姞
button - re-
leasing when the device begins to acti-
vate.
5. If the indicator light on HomeLink
姞
blinks
rapidly for two seconds and then turns
solid, HomeLink
姞
has picked up a “rolling
code” garage door opener signal. You will
need to proceed with the next steps to
train HomeLink
姞
, completing the pro-
gramming may require a ladder and an-
other person for convenience.
6. Push and release the program button
located on the garage door opener’s mo-
tor to activate the “training mode”. This
button is usually located near the an-
tenna wire that hangs down from the
motor. If the wire originates from under a
light lens, you will need to remove the
lens to access the training button.
NOTE:
Once you have pushed and released the
training button on the garage door opener’s
motor and the “training light” is lit, you have
30 seconds in which to perform step 7. For
convenience, use the help of a second person
to assist when performing this step.
SIC3612
SIC3613
2-58
Instruments and controls
췽
—
—
07/15/10—tbrooks
墍