![background image](/i/infiniti/153108/infiniti-m56-2011/h/infiniti-m56-2011-436.png)
REPLACING
Replace the wiper blades if they are worn.
Before replacing the wiper blades, the wiper
should be in the fully up position to avoid
scratching the engine hood or damaging the
wiper arm. To pull up the wiper arm, see
“WINDSHIELD WIPER AND WASHER SWITCH” in
the “2. Instruments and controls” section.
1. Pull the wiper arm.
2. Push the release tab
䊊
A
, and then move
the wiper blade down the wiper arm
䊊
1
while pushing the release tab to remove.
3. Insert the new wiper blade onto the wiper
arm until a click sounds.
4. Rotate the wiper blade so the dimple is in
the groove.
CAUTION
●
After wiper blade replacement, return the
wiper arm to its original position;
otherwise it may be damaged when the hood
is opened.
●
Make sure the wiper blades contact the
glass; otherwise the arm may be damaged
from wind pressure.
If you wax the surface of the hood, be careful
not to let wax get into the washer nozzle
䊊
A
.
This may cause clogging or improper wind-
shield washer operation. If wax gets into the
nozzle, remove it with a needle or small pin
䊊
B
.
Be careful not to damage the nozzle.
SDI2048
SDI2362
Maintenance and do-it-yourself
8-21
췽
—
—
01/13/10—pattie
墍