![background image](/i/infiniti/153108/infiniti-m56-2011/h/infiniti-m56-2011-131.png)
1. Push and hold the desired HomeLink
姞
button.
Do not
release the button until
step 4 has been completed.
2. When the indicator light begins to flash
slowly (after 20 seconds), position the
hand-held transmitter 2 to 5 in (50 to 127
mm) away from the HomeLink
姞
surface.
3. Push and hold the hand-held transmitter
button.
4. The HomeLink
姞
indicator light will flash,
first slowly and then rapidly. When the
indicator light begins to flash rapidly,
release both buttons.
The HomeLink
姞
Universal Transceiver button
has now been reprogrammed. The new device
can be activated by pushing the HomeLink
姞
button that was just programmed. This proce-
dure will not affect any other programmed
HomeLink
姞
buttons.
IF YOUR VEHICLE IS STOLEN
If your vehicle is stolen, you should change the
codes of any non-rolling code device that has
been programmed into HomeLink
姞
. Consult the
Owner’s Manual of each device or call the
manufacturer or retailer of those devices for
additional information.
When your vehicle is recovered, you will need to
reprogram the HomeLink
姞
Universal Transceiver
with your new transmitter information.
FCC Notice:
This device complies with Part 15 of FCC Rules
and RSS-Gen of IC Rules. Operation is subject to
the following two conditions: (1) this device may
not cause interference, and (2) this device must
accept any interference, including interference
that may cause undesired operation of this de-
vice.
2-60
Instruments and controls
췽
—
—
07/15/10—tbrooks
墍