![background image](/i/infiniti/153108/infiniti-m56-2011/h/infiniti-m56-2011-334.png)
SYSTEM MAINTENANCE
●
The two radar sensor units
䊊
1
for the BSW
and BSI systems are located near the rear
bumper. Always keep the area near the radar
sensors clean. Do not attach stickers (includ-
ing transparent material), install accessories
or apply additional paint near the radar
sensors. Do not strike or damage the area
around the radar sensors. Consult an
INFINITI retailer if the area around the radar
sensors is damaged due to a collision.
●
The BSI system uses the same camera
䊊
2
that is used by the LDW/LDP system located
in front of the inside mirror.
For maintenance of the camera, see “LANE
DEPARTURE WARNING (LDW) SYSTEM/LANE DE-
PARTURE PREVENTION (LDP) SYSTEM” earlier in
this section.
Radio frequency statement
This device complies with part 15 of the FCC
Rules and RSS-310 of Industry Canada.
Operation is subject to the following two con-
ditions:
1. This device may not cause harmful inter-
ference.
2. This device must accept any interference
received, including interference that may
cause undesired operation.
Frequency of operation: 24.05GHz — 24.25GHz
Field Strength: Not greater than 2.5V/m peak
(0.25V/m average) at a distance of 3 m
The manufacturer is not responsible for any
radio or TV interference caused by unauthorized
modifications to this equipment. Such modifi-
cations could void the user’s authority to oper-
ate the equipment.
PRECAUTIONS ON CRUISE CONTROL
●
If the cruise control system malfunctions, it
will cancel automatically. The SET indicator
on the dot matrix crystal display will then
blink to warn the driver.
●
If the engine coolant temperature becomes
excessively high, the cruise control system
will be canceled automatically.
●
If the SET indicator blinks, turn the cruise
control main switch off and have the system
checked by your INFINITI retailer.
●
The SET indicator may sometimes blink
when the cruise control main switch is
turned
ON
while
pushing
the
RESUME/ACCELERATE, SET/COAST or CAN-
CEL switch. To properly set the cruise control
system, perform the steps below in the order
indicated.
WARNING
Do not use the cruise control when driving un-
der the following conditions:
●
when it is not possible to keep the vehicle at
a set speed
●
in heavy traffic or in traffic that varies in
speed
●
on winding or hilly roads
SSD1027
CRUISE CONTROL
Starting and driving
5-39
췽
—
—
01/12/10—pattie
墍