Инструкция для ZYXEL ZyWALL 110

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Chapter 7 Interfaces

ZyWALL 110/310/1100 Series User’s Guide

137

User Name

This field displays when you select an authentication type other than None. This field
is read-only if you selected Device in the profile selection. If this field is configurable,
enter the user name for this 3G card exactly as the service provider gave it to you.

You can use 1 ~ 64 alphanumeric and

#:%-_@$./

characters. The first character must

be alphanumeric or

-_@$./

. Spaces are not allowed.

Password

This field displays when you select an authentication type other than None. This field
is read-only if you selected Device in the profile selection and the password is included
in the 3G card’s profile. If this field is configurable, enter the password for this SIM
card exactly as the service provider gave it to you.

You can use 0 ~ 63 alphanumeric and

`~!@#$%^&*()_-+={}|;:'<,>./

characters.

Spaces are not allowed.

Retype to

Confirm

This field displays when you select an authentication type other than None. This field
is read-only if you selected Device in the profile selection and the password is included
in the 3G card’s profile. If this field is configurable, re-enter the password for this SIM
card exactly as the service provider gave it to you.

SIM Card Setting

PIN Code

This field displays with a GSM or HSDPA 3G card. A PIN (Personal Identification
Number) code is a key to a 3G card. Without the PIN code, you cannot use the 3G
card.

Enter the 4-digit PIN code (0000 for example) provided by your ISP. If you enter the
PIN code incorrectly, the 3G card may be blocked by your ISP and you cannot use the
account to access the Internet.

If your ISP disabled PIN code authentication, enter an arbitrary number.

Retype to

Confirm

Type the PIN code again to confirm it.

Interface
Parameters

Egress

Bandwidth

Enter the maximum amount of traffic, in kilobits per second, the ZyWALL can send
through the interface to the network. Allowed values are 0 - 1048576. This setting is
used in WAN load balancing and bandwidth management.

Ingress

Bandwidth

This is reserved for future use.

Enter the maximum amount of traffic, in kilobits per second, the ZyWALL can receive
from the network through the interface. Allowed values are 0 - 1048576.

MTU

Maximum Transmission Unit. Type the maximum size of each data packet, in bytes,
that can move through this interface. If a larger packet arrives, the ZyWALL divides it
into smaller fragments. Allowed values are 576 - 1492. Usually, this value is 1492.

Connectivity Check

The interface can regularly check the connection to the gateway you specified to make
sure it is still available. You specify how often the interface checks the connection, how
long to wait for a response before the attempt is a failure, and how many consecutive
failures are required before the ZyWALL stops routing to the gateway. The ZyWALL
resumes routing to the gateway the first time the gateway passes the connectivity
check.

Enable

Connectivity

Check

Select this to turn on the connection check.

Check Method

Select the method that the gateway allows.

Select icmp to have the ZyWALL regularly ping the gateway you specify to make sure
it is still available.

Select tcp to have the ZyWALL regularly perform a TCP handshake with the gateway
you specify to make sure it is still available.

Table 49

Configuration > Network > Interface > Cellular > Add (continued)

LABEL

DESCRIPTION