Инструкция для ZYXEL ZyWALL 110

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Chapter 4 Quick Setup Wizards

ZyWALL 110/310/1100 Series User’s Guide

Figure 37

VPN Advanced Wizard: Phase 1 Settings

• Secure Gateway: Any displays in this field if it is not configurable for the chosen scenario.

Otherwise, enter the WAN IP address or domain name of the remote IPSec device (secure
gateway) to identify the remote IPSec device by its IP address or a domain name. Use 0.0.0.0 if
the remote IPSec device has a dynamic WAN IP address.

• My Address (interface): Select an interface from the drop-down list box to use on your

ZyWALL.

• Negotiation Mode: Select Main for identity protection. Select Aggressive to allow more

incoming connections from dynamic IP addresses to use separate passwords.

Note: Multiple SAs connecting through a secure gateway must have the same negotiation

mode.

• Encryption Algorithm: 3DES and AES use encryption. The longer the key, the higher the

security (this may affect throughput). Both sender and receiver must use the same secret key,
which can be used to encrypt and decrypt the message or to generate and verify a message
authentication code. The DES encryption algorithm uses a 56-bit key. Triple DES (3DES) is a
variation on DES that uses a 168-bit key. As a result, 3DES is more secure than DES. It also
requires more processing power, resulting in increased latency and decreased throughput.
AES128 uses a 128-bit key and is faster than 3DES. AES192 uses a 192-bit key, and AES256
uses a 256-bit key.

• Authentication Algorithm: MD5 gives minimal security and SHA512 gives the highest

security. MD5 (Message Digest 5) and SHA (Secure Hash Algorithm) are hash algorithms used to
authenticate packet data. The stronger the algorithm the slower it is.

• Key Group: DH5 is more secure than DH1 or DH2 (although it may affect throughput). DH1

(default) refers to Diffie-Hellman Group 1 a 768 bit random number. DH2 refers to Diffie-Hellman
Group 2 a 1024 bit (1Kb) random number. DH5 refers to Diffie-Hellman Group 5 a 1536 bit
random number.

• SA Life Time: Set how often the ZyWALL renegotiates the IKE SA. A short SA life time increases

security, but renegotiation temporarily disconnects the VPN tunnel.

• NAT Traversal: Select this if the VPN tunnel must pass through NAT (there is a NAT router

between the IPSec devices).

Note: The remote IPSec device must also have NAT traversal enabled. See the help in the

main IPSec VPN screens for more information.