Chapter 3 Hardware Introduction
ZyWALL 110/310/1100 Series User’s Guide
39
3.4 Wall-mounting
See
for the ZyWALL models that can be wall-mounted. Do the following to
attach your ZyWALL to a wall.
1
Screw two screws with 6 mm ~ 8 mm (0.24" ~ 0.31") wide heads into the wall 150 mm apart (see
the figure in step 2). Do not screw the screws all the way in to the wall; leave a small gap between
the head of the screw and the wall.
The gap must be big enough for the screw heads to slide into the screw slots and the connection
cables to run down the back of the ZyWALL.
Note: Make sure the screws are securely fixed to the wall and strong enough to hold the
weight of the ZyWALL with the connection cables.
2
Use the holes on the bottom of the ZyWALL to hang the ZyWALL on the screws.
3.5 Front Panel LEDs
This section introduces the ZyWALL’s front panel LEDs.