Инструкция для ZYXEL ZyWALL 110

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Chapter 7 Interfaces

ZyWALL 110/310/1100 Series User’s Guide

152

Each field is explained in the following table.

Table 53

Configuration > Network > Interface > VLAN > Create Virtual Interface

LABEL

DESCRIPTION

IPv4/IPv6 View /
IPv4 View / IPv6
View

Use this button to display both IPv4 and IPv6, IPv4-only, or IPv6-only configuration
fields.

Show Advanced
Settings / Hide
Advanced Settings

Click this button to display a greater or lesser number of configuration fields.

Create New Object

Click this button to create a DHCPv6 lease or DHCPv6 request object that you may use
for the DHCPv6 settings in this screen.

General Settings

Enable Interface Select this to turn this interface on. Clear this to disable this interface.

General IPv6
Setting

Enable IPv6

Select this to enable IPv6 on this interface. Otherwise, clear this to disable it.

Interface Properties

Interface Type

Select one of the following option depending on the type of network to which the
ZyWALL is connected or if you want to additionally manually configure some related
settings.

internal is for connecting to a local network. Other corresponding configuration
options: DHCP server and DHCP relay. The ZyWALL automatically adds default SNAT
settings for traffic flowing from this interface to an external interface.

external is for connecting to an external network (like the Internet). The ZyWALL
automatically adds this interface to the default WAN trunk.

For general, the rest of the screen’s options do not automatically adjust and you must
manually configure a policy route to add routing and SNAT settings for the interface.

Interface Name

This field is read-only if you are editing an existing VLAN interface. Enter the number of
the VLAN interface. You can use a number from 0~4094. For example, vlan0, vlan8,
and so on. The total number of VLANs you can configure on the ZyWALL depends on
the model.

Zone

Select the zone to which the VLAN interface belongs.

Base Port

Select the Ethernet interface on which the VLAN interface runs.

VLAN ID

Enter the VLAN ID. This 12-bit number uniquely identifies each VLAN. Allowed values
are 1 - 4094. (0 and 4095 are reserved.)

Description

Enter a description of this interface. It is not used elsewhere. You can use alphanumeric
and

()+/:=?!*#@$_%-

characters, and it can be up to 60 characters long.

IP Address
Assignment

Get

Automatically

Select this if this interface is a DHCP client. In this case, the DHCP server configures
the IP address, subnet mask, and gateway automatically.

You should not select this if the interface is assigned to a VRRP group.

Use Fixed IP

Address

Select this if you want to specify the IP address, subnet mask, and gateway manually.

IP Address

This field is enabled if you select Use Fixed IP Address.

Enter the IP address for this interface.

Subnet Mask

This field is enabled if you select Use Fixed IP Address.

Enter the subnet mask of this interface in dot decimal notation. The subnet mask
indicates what part of the IP address is the same for all computers in the network.