Chapter 9 Policy and Static Routes
ZyWALL 110/310/1100 Series User’s Guide
191
9.2.1 Policy Route Edit Screen
Click Configuration > Network > Routing to open the Policy Route screen. Then click
the Add
or Edit icon in the IPv4 Configuration or IPv6 Configuration section. The Add Policy Route or
Policy Route Edit screen opens. Use this screen to configure or edit a policy route. Both IPv4 and
IPv6 policy route have similar settings except the Address Translation (SNAT) settings.
DSCP Code
This is the DSCP value of incoming packets to which this policy route applies.
any means all DSCP values or no DSCP marker.
default means traffic with a DSCP value of 0. This is usually best effort traffic
The “af” entries stand for Assured Forwarding. The number following the “af”
identifies one of four classes and one of three drop preferences. See
Forwarding (AF) PHB for DiffServ on page 197
for more details.
Service
This is the name of the service object. any means all services.
Source Port
This is the name of a service object. The ZyWALL applies the policy route to the
packets sent from the corresponding service port. any means all service ports.
Next-Hop
This is the next hop to which packets are directed. It helps forward packets to their
destinations and can be a router, VPN tunnel, outgoing interface or trunk.
DSCP Marking
This is how the ZyWALL handles the DSCP value of the outgoing packets that match
this route. If this field displays a DSCP value, the ZyWALL applies that DSCP value to
the route’s outgoing packets.
preserve means the ZyWALL does not modify the DSCP value of the route’s outgoing
packets.
default means the ZyWALL sets the DSCP value of the route’s outgoing packets to 0.
The “af” choices stand for Assured Forwarding. The number following the “af”
identifies one of four classes and one of three drop preferences. See
Forwarding (AF) PHB for DiffServ on page 197
for more details.
SNAT
This is the source IP address that the route uses.
It displays none if the ZyWALL does not perform NAT for this route.
Apply
Click Apply to save your changes back to the ZyWALL.
Reset
Click Reset to return the screen to its last-saved settings.
Table 67
Configuration > Network > Routing > Policy Route (continued)
LABEL
DESCRIPTION