Инструкция для ZYXEL ZyWALL 110

(скачивание инструкции бесплатно)

Формат файла: PDF

Доступность: Бесплатно как и все руководства на сайте. Без регистрации и SMS.

Дополнительно: Чтение инструкции онлайн

Chapter 7 Interfaces

ZyWALL 110/310/1100 Series User’s Guide

138

Check Period

Enter the number of seconds between connection check attempts.

Check Timeout

Enter the number of seconds to wait for a response before the attempt is a failure.

Check Fail

Tolerance

Enter the number of consecutive failures before the ZyWALL stops routing through the
gateway.

Check Default

Gateway

Select this to use the default gateway for the connectivity check.

Check this

address

Select this to specify a domain name or IP address for the connectivity check. Enter
that domain name or IP address in the field next to it.

Check Port

This field only displays when you set the Check Method to tcp. Specify the port
number to use for a TCP connectivity check.

Related Setting

Configure WAN

TRUNK

Click WAN TRUNK to go to a screen where you can configure the interface as part of
a WAN trunk for load balancing.

Configure Policy

Route

Click Policy Route to go to the policy route summary screen where you can configure
a policy route to override the default routing and SNAT behavior for the interface.

IP Address
Assignment

Get

Automatically

Select this option If your ISP did not assign you a fixed IP address. This is the default
selection.

Use Fixed IP

Address

Select this option If the ISP assigned a fixed IP address.

IP Address

Assignment

Enter the cellular interface’s WAN IP address in this field if you selected Use Fixed IP
Address.

Metric

Enter the priority of the gateway (if any) on this interface. The ZyWALL decides which
gateway to use based on this priority. The lower the number, the higher the priority. If
two or more gateways have the same priority, the ZyWALL uses the one that was
configured first.

Device Settings

Network

Selection

This field appears if you selected a 3G device that allows you to select the type of
network to use. Select the type of 3G service for your 3G connection. If you are unsure
what to select, check with your 3G service provider to find the 3G service available to
you in your region.

Select auto to have the card connect to an available network. Choose this option if you
do not know what networks are available.

You may want to manually specify the type of network to use if you are charged
differently for different types of network or you only have one type of network
available to you.

Select GPRS / EDGE (GSM) only to have this interface only use a 2.5G or 2.75G
network (respectively). If you only have a GSM network available to you, you may
want to select this so the ZyWALL does not spend time looking for a WCDMA network.

Select UMTS / HSDPA (WCDMA) only to have this interface only use a 3G or 3.5G
network (respectively). You may want to do this if you want to make sure the interface
does not use the GSM network.

Table 49

Configuration > Network > Interface > Cellular > Add (continued)

LABEL

DESCRIPTION