Chapter 44 Troubleshooting
ZyWALL 110/310/1100 Series User’s Guide
536
If you want to reboot the device without changing the current configuration, see
.
1
Make sure the SYS LED is on and not blinking.
2
Press the RESET button and hold it until the SYS LED begins to blink. (This usually takes about five
seconds.)
3
Release the RESET button, and wait for the ZyWALL to restart.
You should be able to access the ZyWALL using the default settings.
44.2 Getting More Troubleshooting Help
Search for support information for your model at www.zyxel.com for more troubleshooting
suggestions.