Amp, Cab & Mic Models
6•2
• Each Amp Block can be individually set to a different Amp or Preamp Model,*
edited and enabled/disabled.
*Note: Some Amp/Preamp Models utilize more DSP than others. You may find it necessary
to bypass or remove some FX Models to enable two simultaneous Amps - see
• The Amp Blocks cannot be moved
within the A or B Paths, however, it is possible
to move any FX Blocks before or after the Amps within either Path.
• Specific behaviors apply for moving an Amp Block
out of the parallel Paths A/B:
• Select Amp A, push the
MOVE
button, then the Nav. Disc button. This
removes Amp B from the tone and moves Amp A to the Post position, where it
is placed directly after the Mixer (and before any “Post” FX).
• Select Amp A, push the
MOVE
button, then press the Nav. Disc button. This
removes Amp B from the tone and moves Amp A to the Pre position, where it is
placed just before the Path A/B split (and after any “Pre” FX).
• For the above actions, pressing
MOVE
when Amp B is selected has no function.
Amp Block in Pre or Post Positions
Only a single Amp Block can be used within either of these positions.
Amp A
Amp in “Pre” position (before Path A & B)
With the Amp in Pre, as shown above, the single amp feeds both Paths A & B. You can
always move FX into either Path A or B, in which case they’ll behave as “Post Amp” FX,
yet be in parallel, with each Path’s output controlled by the Mixer’s A & B Level and Pan.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
