- 15 -

Installation Conditions

1

1.

Setup

●

●

Installation Conditions

Placement Environment

Your printer must be placed in the following 

environment:

Temperature:

10°C–32°C 

Humidity:

20%–80% RH (relative humidity)

Maximum 

wet bulb 

temperature:

25°C

Recommended 

environment:

Temperature 17°C–27°C, 

Humidity 50%–70% RH

Note

●

Be careful of condensation. It may cause a malfunction.

●

If placing your printer in a location where the humidity of 

the surrounding air is less than 30% RH, use a humidifier 

or antistatic mat.

WARNING

● Do not install near high temperature or the fire.

●

Do not install in a place from which a chemical 

reaction is started (laboratory etc.).

● Do not install near the inflammable solution, such 

as alcohol and thinner.

●

Do not install the unit within the reach of small 

children.

●

Do not install in an unstable place (the shaky 

stand, leaning place, etc.).

●

Do not install the unit in a place where it comes 

into contact with high humidity, dust, or direct 

sunlight.

●

Do not install in an environment of briny air or 

corrosive gas.

●

Do not install in a place with much vibration.

●

Do not install in a place where the ventilation hole 

of the printer is closed.

CAUTION

●

Do not place directly on a rug or carpet with long 

strands.

●

Do not install in a closed room with poor 

ventilation and circulation.

●

If you use the printer in a small room for a long 

time, please make sure that you ventilate the 

room.

● Install away from strong magnetic fields and 

sources of noise.

●

Install away from monitors or TVs.

Placement Space

Place your printer on a flat surface large enough 

to support printer’s all feet.
Allow for enough room around your printer as 

shown in the images below.

●

Top view

20 cm

20 cm

100 cm

60 cm

●

Side view

70 cm